\documentclass[11pt,twoside,a4paper]{article}
\usepackage{pgm}

%\input{definition.tex}
%%%%%%%% Some definitions, previously in a separate file %%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
\usepackage{amsthm}

%%% environments of theorem like style - i.e. printed in italics
\newtheorem{theorem}{Theorem}%[section]
\newtheorem{lemma}{Lemma}%[section]
\newtheorem{assertion}{Assertion}%[section]
\newtheorem{conjecture}{Conjecture}
\newtheorem{corollary}{Corollary}%[section]
\newtheorem{proposition}{Proposition}%[section]

%%% definitions of ``example'' and ``definition'' numbered environments in the standard
%%% font of the submission
\theoremstyle{definition}
\newtheorem{definition}{Definition}%[section]
\newtheorem{example}{Example}%[section]

%%% definition of ``remark'', a not numbered environment, printed in the standard
%%% font of the submission
\theoremstyle{remark}
\newtheorem*{remark}{Remark}%[section]
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%

%%%% START HERE: %%%%%%%%%%%%%%%

\title{Instructions for PGM'2010 Submissions}
\author{Petri Myllym\"aki\\
University of Helsinki, Finland\\
petri.myllymaki@cs.helsinki.fi
\AND
Teemu Roos\\
Helsinki Institute for Information Technology, Finland\\
teemu.roos@hiit.fi
}

\summary{%
  This document is an example of how your manuscript submitted to
  PGM'2010 should look. Authors are asked to follow the
  directions reported in this document. Papers that do not conform to the
  specified length and formatting requirements can be rejected without any
  review.}

\pagestyle{empty}
\begin{document}
\maketitle
\section{Introduction}

This document provides instructions for preparing papers
for the PGM workshop. This document has been developed based on similar documents 
used for different conferences like ACL and EACL annual
meetings and written by several authors.

\section{General Instructions}

The page limit for PGM submissions is eight ($8$) pages. All
illustrations, references, and appendices must be accommodated within
the page limit, following the formatting instructions given in
this document. 

Print all text, including section titles and figures,
in two-column format where each column is 7.6 cm by 23.5 cm 
and there is a 0.6 cm space between the two
columns. Exceptions to the two-column format include the title,
authors (and affiliations), the abstract, and possibly also figures or
tables. Start all pages directly below the top margin. 
On A4 paper, the left margin is 3.1 cm and the right
margin is 2.5 cm on an odd page.
On an even page the margins are interchanged to allow proper binding of 
the two-sided printing. At the top of each page the margin is 3.0 cm. 
Type single-spaced. Indent when starting a new
paragraph. Use standard fonts such as Times Roman or Computer Modern
Roman, with 11 points for text and 14 to 16 points for headings and
title.


\subsection{Electronically available resources}

This file ({\tt pgm-author-instructions.tex}) and the  \LaTeX \, style file used
  ({\tt pgm.sty}) 
  %and the ACL bibliography style ({\tt acl.bst}) are
 are both available from the workshop homepage
   \begin{center}
 {\tt http://www.helsinki.fi/pgm2010/}
\end{center}

\subsection{The First Page}

Center the title, authors' names and affiliations, and the abstract
across both columns. Use the two-column format only when you begin the
main body of the text.

\paragraph{Title:} Place the title at the top of the first page, a long title
should be typed on two or more lines without a blank line
intervening. Put the title at approximately 0.8cm (0.3in) from the
top margin of the page.

\paragraph{Authors' names:} Place the authors' names just below the title,
leaving an extra space of 0.2cm (.1in) between the title and the
authors' names.

\paragraph{Abstract:} The width of the text in the abstract should be smaller than
the combined width of the columns for the text in the body of the paper by
about 0.7cm (0.3in) on each side.  Center the word {\bf Abstract} in
boldface type above the body of the abstract. Leave an extra space of
0.4cm (.2in) between the authors' names and the abstract. The abstract
should be no longer than 200 words.

\paragraph{Text:} Begin typing the main body of the text immediately
after the abstract, observing the two-column format as shown in this
example.


\subsection{Sections}

\paragraph{Headings:} Type and label section and subsection headings in
the style shown on these pages. Use numbered sections, in order to
facilitate cross references.

\paragraph{References:} Citations within the text could appear in
parentheses as \cite{jensen-book2001} or, if the author's name appears
in the text itself, as \newcite{buntine1996}. It is also possible
to use only the year like \shortcite{shachter-peot1992} if there is no
ambiguity. Gather the full set of references together
under the heading {\bf References}; place them before any {\bf
Appendices}, unless the appendices contain references. Arrange the references
alphabetically by the first author, rather than in the order of occurrence in
the text.  Provide as complete citations as possible, use a
consistent format. The provided \LaTeX and BibTeX style files loosely conform to the
APA format.

\paragraph{Appendices:} Appendices, if any, should follow the text and the
references (but see above). Letter them in a sequence and provide a
brief title: {\bf Appendix A. Title of Appendix.}


\subsection{Footnotes}

\paragraph{Footnotes:} 
Put footnotes at the bottom of the page. They may be numbered or
referred to by asterisks or other symbols.\footnote{This is what a
footnote should look like.} Footnotes should be separated from the text
by a line.\footnote{Note the line separating the footnotes from the
text.}

\subsection{Graphics}

\paragraph{Illustrations:} 
Place figures, tables, and photographs in the paper near where they
are first discussed, rather than at the end, if possible.  Wide
illustrations may run across both columns.

\paragraph{Captions:} 
Provide a caption for every illustration; number them sequentially
in the form: ``Figure 1. Caption of the Figure.'' ``Table 1.  Caption
of the Table.''  Place the captions for figures below the figures.
Place the captions for tables above the tables.

\subsection{Mathematical Environments}

In this subsection we illustrate how mathematical environments should look.

\begin{definition}[Optional name]
Definitions are in the standard font of the submission. 
The word ``Definition'' is in boldface. 
Definitions are numbered. 
\end{definition}

\begin{theorem}[Optional name]
Theorems are in italics. The word ``Theorem'' is in boldface. 
Theorems are numbered. 
\end{theorem}
\begin{proof}
Proofs are printed in the standard font of the submission. 
The word ``Proof'' is in italics. 
Proofs are not numbered. 
Proofs end with an Q.E.D symbol.
\end{proof}

\begin{lemma}[Optional name]
Lemmas are in italics. The word ``Lemma'' is in boldface. 
Lemmas are numbered. 
\end{lemma}

\begin{assertion}[Optional name]
Assertions are in italics. The word ``Assertion'' is in boldface. 
Assertions are numbered. 
\end{assertion}

\begin{conjecture}[Optional name]
Conjectures are in italics. 
The word ``Conjecture'' is in boldface. 
Conjectures are numbered. 
\end{conjecture}

\begin{corollary}[Optional name]
Corollaries are in italics. 
The word ``Corollary'' is in boldface. 
Corollaries are numbered. 
\end{corollary}

\begin{proposition}[Optional name]
Propositions are in italics. 
The word ``Proposition'' is in boldface. 
Propositions are numbered. 
\end{proposition}

\begin{example}[Optional name]
Examples are in the standard font of the submission. 
The word ``Example'' is in boldface. 
Examples are numbered. 
\end{example}

\begin{remark}[Optional name]
Remarks are in the standard font of the submission. 
The word ``Remark'' is in italics. 
Remarks are not numbered.
\end{remark}


\section{Submission Procedure}

There is no separate deadline for submitting abstracts. The authors must prepare their paper according to the PGM proceedings format, and submit the full version of their paper as a single PDF file by the deadline of {\bf June 4, 2010, Midnight UMT}. 

The name of the file should be 
\begin{center}
{\tt lastnameoffirstauthor.pdf}.
%\
%or \\
%{\tt lastnameoffirstauthor.ps} 
\end{center}

Hence, for example if this file would be submitted to PGM'2010, it should be named {\tt myllymaki.pdf}. (NB. The first author will appear in the author index of the Proceedings according to this,  so e.g., if the file is named "decampos.pdf", the first author will appear under "D", if "campos.pdf", then under "C". )

The submissions must be entered using the Confmaster conference management system at
\begin{center}
 {\tt http://pgm.confmaster.net}
\end{center}


\subsection*{Acknowledgments}

Acknowledgements should appear as the last unnumbered subsection of the paper. 
% The first (and better) option for the bibliography is to use 
% the acl bibliography style together with your BibTex file 
% - in our example it is sample.bib
% - to use BibTex delete comments on the next two lines and comment the whole bibliography below
%
%\bibliographystyle{acl}
%\bibliography{sample}

% The second option is to include bibliography directly in the LaTex file as it is
% shown next:
\begin{thebibliography}{}

\bibitem[\protect\citename{Buntine}1996]{buntine1996}
Wray Buntine. 1996. A guide to the literature on learning probabilistic networks from
data. {\em IEEE Trans. on Knowledge and Data Engineering}, 8(2):195--210.

\bibitem[\protect\citename{Jensen}2001]{jensen-book2001}
Finn~V. Jensen. 2001. {\em Bayesian Networks and Decision Graphs}.
Springer Verlag.

\bibitem[\protect\citename{Shachter and Peot}1992]{shachter-peot1992}
Ross~D. Shachter and Mark~A. Peot. 1992.
Decision making using probabilistic inference methods.
In {\em 8th Conferece on Uncertainty in Artificial Intelligence}, 
pages 276--283.

\end{thebibliography}

\end{document}
